CONVEYOR BELTS

=============================

Conveyor Belts

1. In 2D mode, make a basic room.  In 3D mode,  adjust the ceiling 

height and texture to your liking.

2. In 2D mode, create a rectangle somewhere in the room. Go into 3D 

mode and raise or lower it as desired.  Give it  a texture of your choice.  Water, etc. 

This will become your conveyor belt.

3. Place your cursor on the conveyor belt sector in 2D mode. Enter the following input:

<ALT><F5>

Type 0 : Normal

(Scroll down to Fx.., press <Enter>)

Motion Fx:

Speed = 40  (higher the number, the faster it goes)

Angle = 0

x pan floor

x panalways

x drag

If you want to adjust what direction the conveyor belt is moving, use <Alt><F> 

in 3D mode with cursor pointed at conveyor area to align it in the direction you want it to go.

If you want the conveyor to go down the side of a table or wall, then press <Alt><F6> 

on the red line of the wall in 2D mode, and enter the following:

Trigger Flags:

panY = -40 (again, the higher the number, the faster it goes. -numbers go down and + numbers entered here will make the texture go up

x pan Always

Add an Ambient sound, and save your work. Now you should have a conveyor belt.

This tutorial was corrected by Nailer  ( steveg@ )